GeoSpec12 – Improving measurement capabilities for challenging reservoirs with expanded range of industry leading NMR core analyzers
Green Imaging Technologies and Oxford Instruments are pleased to announce the introduction of GeoSpec12, the latest evolution of the renowned GeoSpec range of nuclear magnetic resonance (NMR) core analyzers. GeoSpec12 addresses the problem of achieving adequate sensitivity when taking measurements from low porosity rocks. The Geospec 12 retains the Q-sense technology, which has been further developed through the collaboration between Oxford Instruments and MRF Innovations to operate at this extended frequency range.
More capability for tight rocks
Benchtop NMR core analyzers have traditionally operated at a frequency of 2MHz, partly in order to avoid susceptibility artefacts caused by paramagnetic material in sandstone samples. Such artefacts are of less concern with shales, but on the other hand measurements on shale are made more difficult by low porosities and small pore sizes resulting in much less fluid from which to obtain an NMR signal. The problem of low sensitivity has now been addressed with the GeoSpec12. The GeoSpec12 operates at 12MHz and retains the Q-Sense technology and Green Imaging Technologies’ software that have made the GeoSpec range so successful.
Expanded range of models
The GeoSpec range of analyzers now comprises industry standard 2MHz units (accommodating a range of sample sizes from half inch to 6 inches in diameter), the 12MHz unit for increased sensitivity when working with low porosity samples and 20MHz instruments for the best short echo performance allowing even the tightest rocks to be analyzed. A dedicated overburden cell, the P5 Cell, is available for most models. The P5 Cell provides NMR users with the technology to pressurize rock core samples up to 5,000 psi and heat them to 100°C, allowing them to make measurements as close to reservoir conditions as possible.